Moose Camlock

Blank Chanter Stock

Installation & Care Instructions

The Moose Camlock Blank Chanter Stock is designed to protect the chanter reed whilst it is not being used in the bagpipes. It has a very simple exterior design combined with a very logical interior to ensure that the chanter reed stays safe and the hemp joint on the chanter remains intact and in good condition.

Easy Installation Instructions

1. Hold the Camlock by the bottom half and twist the top half in an anti-clockwise direction until it stops. This ensures that the 'cam' inside is in the fully open position and will allow the Camlock to fit easily over the chanter.

2. Place the Camlock over the chanter reed and over the hemp section over the chanter. Be very very careful not to touch the reed!

3. Hold the chanter and bottom section of the Camlock securely together in one hand.

4. Twist the top half of the Camlock in a clockwise direction until it tightens enough for the 'cam' to grip/bite the hemp.

#NOTE:- We strongly advise that you perform a few test runs on a chanter without a reed in it. This will allow you to get a feel for how the Camlock works and also how tight you should tighten the cam. And, without any damage to your favourite pipe chanter reed.

If at any time, you have a question about the Moose Camlock Blank Chanter Stock or need some technical support then please do not hesitate to email us and we will be happy to assist.

Technical Support:- Tech Support

Website Created and Maintained by Moose Products©